■ About output data
Measurement data can be transferred and saved in a computer.

□Input Tools

Torque measurement gauge

■ Use for making torque settings on electric drivers, checking torque of torque wrenches or measuring torque of fasteners, etc.
・ Memory function makes saving and managing of torque data possible.
(Up to 100 data measurements)
・ The maximum torque, the minimum torque, and the average torque can be confirmed by Ave measurement function.
・ Automatically recalibrated to zero value.
・ First peak measurement mode (F.PEAK) gives precision measurements of torque wrenches or manual driver.
・ Automatically turns off in reset by the auto-reset timer function(one second, two seconds, and 5 seconds)
□HP Series

■Management of torque for tightening screws
・ Memory function makes saving and managing of torque data possible
(100 data with memory)
・ The maximum torque, the minimum torque, and the average torque can be confirmed by Ave measurement function.
・ Automatically recalibrated to zero value.
・ First peak measuring mode(F.PEAK) gives precision measurements of torque wrenches or other tools(HP series and HDP series.)
・ Automatically turns off by auto reset timer function(1 second, 2 seconds, and 5 seconds)
□HDP Series

■Management of torque for automated driver
・ Measure the torque range in the state of driver owns a bit.
・ Measure if there is even a narrow room or space.
・ Output data and output analogue are for standard use.
□HM Series

■Use for control of torque of impact drivers
・ First peak measuring mode (F.PEAK) gives precision measurements of torque wrenches or other tools.
・ Confirm peak, FP mode value by buzzer.
・ Data output and analogue output are standard spec. characteristics.
□HIT series

■For a torque management of impact driver, torque wrench.
・ Spinning of a top of the inspection gauge gives some roll into the measured object and it measures a load torque of revolution part.
・ Ups and downs of allowance can set the measurement rate and compare the ups and downs judging setting and external output.
・ Confirm OK/NG judgment(LOW-GOOD-HI) with LED lighting lamp.
・ Use as an waving form observation data by output analogue.
・ Set start and stop at external output terminal.
・ Control rotation speed of the shaft.
・ Data output and analogue output are standard spec. characteristics.
□TEM Series (Indication part)
□MDS(Inspection gauge)

■Issuing a certification of calibration